A CNC machine is an automated machine equipped with a program control system. The control system can logically process a program with control codes or other symbolic instructions, and decode it, so that the machine can operate and process parts.
Compared with ordinary machine tools, this kind of CNC machine has higher processing times and stable quality, and is more favored by processing companies. However, it is an automatic equipment, so the voltage requirements are more stringent, otherwise it will seriously affect the product quality.
What harm will the unstable power grid cause to CNC machine?
Overvoltage: It will cause overvoltage alarm of the numerical control system and accelerate the aging and even damage of components.
Undervoltage: If the voltage is too low, the CNC system will issue an undervoltage alarm, the entire CNC system will crash or restart, and the system parameters may be lost.
Voltage fluctuation: It will make the motor run unstable, lose data, pull the relay and contactor, and cause malfunction.
Surge impact: It is easy to cause damage to the CNC system or servo drive components, cause insulation breakdown of electrical equipment, and easily cause system crashes and data errors.
Harmonic interference: The harmonic current generated by the nonlinear load will affect multiple working links of the CNC system, causing system crash, reset, data loss, communication failure and false alarms.
In order to better solve the problem of power grid stability, we recommend using the SBW series of special voltage regulators for CNC machine to provide a clean and pure power environment for CNC.
Here are the main specifications of SBW series voltage stabilizer below.
Input
Voltage
380V+/-20% (three phase), or customized
Frequency
47Hz-63Hz
Output
Rated Voltage
380V±2%
Accuracy
±2%
Response Time
<1S
Waveform Distortion
No additional waveforms generated (static)
Efficiency
≥98%
Protection
Over Voltage
delay 3~5 seconds cut off output, when output voltage over 10%
Under Voltage
delay 3~5 seconds cut off output, when output voltage lower than 15%
Phase Failure
cut off output automatically
Surge protection
with surge protection
Over Current
delay 3~5 seconds cut off output, when over rated current
Short Circuit
cut off output
Bypass
Manually or automatically transfer to DC power supply in case of voltage regulator failure or repair
Noise
<55dB
Relative Humidity
20%~90%
Withstand Voltage
2000VAC
Insulation Resistance
≥2MΩ
EM filtering device
Optional
Working method
Can be long-term continuous unattended work
Cooling System
Self cooling